Customer ID support.
No account required.
Use NFG Customer and NFG Technician for customer-approved remote support. Neither module requires a website account, software license or desktop sign-in. You do not need to register a computer or create a company workspace to follow this guide.
Windows 0.44.5 preview. Windows publisher signatures are not yet available. If Windows blocks an installer, record the exact message and ask your technician for help. Do not disable Windows security controls. Internet USB and ECU programming are not qualified for unrestricted production use.
For the customer
- Download the Customer installer (.exe) and run setup on the Windows computer that needs help.
- Open NFG Customer and keep it open while it prepares your customer ID.
- Share the customer ID only with the technician you expect. The technician enters it in NFG Technician to request a connection.
- Verify the technician and the verification code shown in the local approval prompt. Approve only the access you intend to allow, and accept the intended technician in the RustDesk prompt when shown. Installing the app or sharing an ID does not itself authorize access.
- Stay at the computer during attended support. Use STOP ALL ACCESS to end managed access. Closing NFG ends its temporary session and managed access.
For the technician
- Download the Technician installer, run setup and open NFG Technician. No website account or desktop credentials are needed.
- Ask the customer to open NFG Customer and share the customer ID displayed there.
- Enter that ID in NFG Technician and request the connection.
- Wait for the customer to verify and approve you locally. After approval, choose Connect to customer PC and wait for the customer's RustDesk acceptance when prompted.
- Confirm the intended connection on both computers before starting work. End the session when finished.
USB permission is separate
Screen access does not approve USB sharing. On the customer computer, open USB connection, select the intended adapter by name and choose Share selected USB. On the technician computer, select that device by name and choose Connect selected USB.
Internet USB needs a configured relay and compatible drivers. Technician receiving drivers change only through Install / repair USB. Compatibility and restart checks can block setup; approve Windows prompts only during the explicit repair. Test the actual adapter on both PCs. Device inventory is not proof of successful diagnostic communication.
Use STOP ALL ACCESS when finished and verify the device is no longer shared or attached. Do not begin ECU programming on the basis of this guide.
If a connection does not start
Keep both modules open and check that both computers are online. Confirm the customer ID and the intended technician. A lost connection ends access and requires fresh approval. Do not share a website password or remove security protections to get connected.
Record the exact error, which module shows it and the Windows version, then contact your technician. You can return to the setup checklist without signing in.
Company accounts are separate
Website sign-in is for managing company workspaces, service requests and account records. It is not required for the Customer ID support steps above.